Day 5 - Now It's Looking Like A Motor Again!
All the header bolts are tightened using an hex wrench and a piece of conduit. Not pretty but effective. Reinstalled the A/C compressor bracket and pressed the pulled back on the pump.
The rocker arms are installed.
Prepped the intake manifold with new O rings on the injectors and sealed all the plugs and the sensor. Wrestled the intake back in (twice) without removing the distributor. Reinstalled the valve covers and began connecting all the wiring.
The left side of the engine is completed with the exceptions of the spark plugs and wires. Those will be the final contortionist act for this side. With some luck I should get to fire it up tomorrow.